1E-9 Engine Lubrication System:
Oil Cooler And Oil Hose Components
B827H11506009
Oil Cooler / Oil Cooler Hose Inspection and
Cleaning
B827H11506010
Oil Cooler Hose Inspection
Inspect the oil cooler hoses in the following procedures:
1) Remove the left inner fender. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
2) Inspect the oil cooler hoses for any damage and oil
leakage. If any defects are found, replace the oil
cooler hose with new ones.
1
3
5
4
2
(a)
(a)
(a)
(a)
5
5
5
FWD
I827H1150048-02
1. Oil cooler : 10 N⋅m (1.0 kgf-m, 7.0 lb-ft)
2. Oil cooler fin guard net : Apply grease.
3. Oil hose (inlet) : Apply thread lock.
4. Oil hose (outlet) : Do not reuse.
5. O-ring
I827H1150022-01
I827H1150023-01
To Next Page
Loading...
Need help?
General
