Propeller Shafts: 3D-13
Insert the universal joint to the bearing and check the
play by turning the universal joint, as shown. If excessive
play is noted, replace the bearing with a new one.
Front Output Shaft Related Parts Inspection (LT-
A400F, LT-F400F)
B827H13406020
Refer to “Front Output Shaft Disassembly and Assembly
(LT-A400F, LT-F400F) (Page 3D-10)”.
Front Output Shaft (LT-A400F, LT-F400F)
Inspect the front output shaft for distortion.
If distortion is found, replace the front output shaft with a
new one.
Front Output Shaft Oil Seal (LT-A400F, LT-F400F)
Visually inspect the oil seal for damage, with particular
attention given to the lip.
Replace the oil seal that shows indications of leakage.
Front Output Shaft Bearing (LT-A400F, LT-F400F)
Inspect the front output shaft bearing for abnormal noise
and smooth rotation.
Replace the bearing if there is anything unusual.
Drive Bevel Gear Removal and Installation (LT-
A400/F)
B827H13406021
Removal
1) Remove the engine assembly from the frame. Refer
to “Engine Assembly Removal in Section 1D
(Page 1D-6)”.
2) Remove the engine top side. Refer to “Engine Top
Side Disassembly in Section 1D (Page 1D-10)”.
3) Separate the crankcase. Refer to “Engine Bottom
Side Disassembly in Section 1D (Page 1D-34)”.
4) Using a chisel, unlock the nut.
5) Hold the transfer driven gear with the special tool
and remove the driven bevel gear nut.
Special tool
(A): 09920–53740 (Clutch sleeve hub
holder)
I827H1320048-01
I827H1340090-01
I827H1340060-02
I827H1340061-01
I827H1340062-01
To Next Page
Loading...
Need help?
General
