Ignition System: 1H-3
Repair Instructions
Spark Plug Removal and Installation
B827H11806001
Removal
WARNING
!
The hot engine can burn you.
Wait until the engine is cool enough to touch.
1) Turn the ignition switch OFF.
2) Remove the left side cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
3) Disconnect the spark plug cap (1).
4) Remove the spark plug with the spark plug wrench.
Special tool
(A): 09930–10121 (Spark plug wrench set)
Installation
Install the spark plug in the reverse order of removal.
Pay attention to the following points:
• Screw the spark plug into the cylinder head with
fingers, and then tighten it to the specified torque.
CAUTION
!
Do not cross thread or over tighten the spark
plug, or such an operation will damage the
aluminum threads of the cylinder head.
Special tool
: 09930–10121 (Spark plug wrench set)
Tightening torque
Spark plug: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
Spark Plug Inspection and Cleaning
B827H11806002
Refer to “Spark Plug Inspection and Cleaning in Section
0B (Page 0B-6)”.
Ignition Coil and Plug Cap Inspection
B827H11806003
Refer to “Electrical Components Location in Section 0A
(Page 0A-6)”.
Ignition Coil Primary Peak Voltage
1) Remove the left side cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
3)”.
2) Disconnect the spark plug cap.
3) Connect new spark plug to spark plug cap and
ground it to the cylinder head.
NOTE
Be sure that the spark plug is connected
properly and the battery used is in fully-
charged condition.
1
(A)
I827H1180012-02
I827H1180013-01
I827H1180001-01
To Next Page
Loading...
Need help?
General
