Volkswagen CPYC User Manual

Display shows Possible cause of fault Fault remedy
Deviation from
specification
◆ Exhaust gas pressure sensor 1
-G450- defective
– -G450- Check. ⇒ Page 446
5.3.15 Display group 106 - diesel particulate filter,
regeneration 6
Test prerequisites
● Engine running at idling speed.
● Engine warm, coolant temperature not below 80°C.
● Intake air temperature < 40°C.
Display
zone
Operating mode or component Specification Evaluation
1 --- --- ---
2 Diesel particulate filter, fuel consumption
since last regeneration
--- ---
3 Diesel particulate filter, mileage since last
regeneration
--- ---
4 Diesel particulate filter, time since last re-
generation
--- ---
5.3.16 Display group 108 - diesel particulate filter,
regeneration 8
Test prerequisites
● Secure vehicle/machine
● Engine running at idling speed.
● Engine warm, coolant temperature not below 80°C.
● Intake air temperature < 40°C.
Display
zone
Operating mode or component Specification Evaluation
1 Diesel particulate filter, ash deposit mass 0...175 ml
⇒ Page 105
2 Diesel particulate filter, soot loading (cal-
culated)
0...40 g
⇒ Page 105
3 Diesel particulate filter, soot loading
(measured)
0...40 g
⇒ Page 106
4 --- --- ---
Evaluation: display group 108, display zone 1 - diesel par-
ticulate filter, regeneration
Display shows Possible cause of fault Fault remedy
Higher than specifi-
cation
◆ Soot level too high
– Renew diesel particulate filter
⇒ Page 427
Evaluation: display group 108, display zone 2 - diesel par-
ticulate filter, regeneration
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
3
5 Measured value blocks, engine codes CJDA, CJDD
105

Volkswagen CPYC Specifications

General

Brand	Volkswagen
Model	CPYC
Category	Engine
Language	English