Volkswagen CPYC - F - Re-Pressing Sender Wheel

– Install engine speed sender -G28- -arrow-, and tighten se-
curing bolt to 5 Nm.
– Install sump ⇒ Page 244.
– Install intermediate plate.
– Install flywheel using new bolts. Tighten securing bolts to 60
Nm +
1
/
4
turn (90°).
2.5.8 F - Re-pressing sender wheel
– Secure assembly tool -T10134- to crankshaft flange using
hexagon socket head bolts -A-.
– Hand tighten both hexagon socket head bolts -A-.
– Push assembly tool -T10134- by hand to sealing flange.
– Screw hexagon nut -E- onto threaded spindle by hand until it
lies on assembly housing -C-.
– Tighten hexagon nut of assembly tool -T10134- to 40 Nm us-
ing torque wrench -V.A.G 1331- and tool insert, 24 mm
-V.A.G 1332/11-.
– Check installation position of sender wheel on crankshaft
again ⇒ Page 176.
If dimension -a- is too small again:
– Tighten hexagon nut for assembly tool -T10134- to 45 Nm.
– Check installation position of sender wheel on crankshaft
again ⇒ Page 176.
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
3
2 Removing and installing sealing flange and flywheel
177