Note
The applicable service intervals for the gas system must be ob-
tained from the manufacturer of the gas system.
4.4 Descriptions of work, engine, general
In this chapter you will find any scopes of service which cannot
be assigned to one of the repair groups. Any other descriptions
of work can be found in the relevant repair group. All descrip-
tions of work are cross-referenced in the tables for service work
⇒ Page 14 or additional work ⇒ Page 16.
WARNING
Adhere to the general safety regulations and the notes on
repair work on the engine! ⇒ Page 1
4.4.1 Engine and add-on parts in engine com-
partment (from above and below): perform
visual check for leaks and damage
Perform visual check as follows:
– Check engine and components for leaks, damage and
whether they are secured firmly.
– Check lines, hoses and connections of:
â—† exhaust system
â—† fuel system
â—† cooling and heating system
â—† engine oil circuit
â—† air conditioning system
â—† intake system and air lines
for leaks, abrasions, porosity, brittleness and soiling.
Note
â—† Arrange for defects to be rectified as repair measures.
â—† If the fluid loss is greater than can be expected through nor-
mal use, determine the sources, and rectify the defect (re-
pair measure).
4.4.2 Perform road test
Check the following during a road test:
– Engine: output, misfiring, idling speed, acceleration
– Clutch: pulling away, odours
– Air conditioner compressor: functional check (at low temper-
atures the operation of the air conditioner compressor must
be checked in the workshop)
– Engine: hot start behaviour
3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
18
Repair Group 00 - Technical data
To Next Page
Loading...
Need help?
General
