– Install crankshaft pulley. To do this, lock toothed belt pulley
using counterhold -3415-.
– Tighten new central bolt to 120 Nm and
1
/
4
turn (90°) further
(turning further can be done in several stages).
Note
Thread and shoulder must be free of oil and grease.
– How to install and tension toothed belt ⇒ Page 210.
2.3 Removing and installing crankshaft
sealing flange, pulley end
WARNING
Always adhere to the following instructions.
◆ The repair work described in this chapter must be
carried out in a Volkswagen dealership only.
◆ If these instructions are not adhered to and damage
results, Volkswagen is exempt from any liability and
warranty claims.
3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
164
Repair Group 13 - Crankshaft group
To Next Page
Loading...
