2.6 Removing and installing engine speed
sender -G28-
WARNING
Adhere to the general safety regulations and the notes on
repair work on the engine! ⇒ Page 1
Special tools and workshop equipment required
◆ Torque wrench (5…50 Nm) -V.A.G 1331-
Removing ⇒ Page 178.
Installing ⇒ Page 178.
2.6.1 Removing
Depending on the installation space for the engine, the oil filter
bracket and the engine oil cooler may have to be removed.
– Clamp off coolant hoses at oil cooler using hose clamp and
pull off hoses.
– Remove oil filter bracket ⇒ Page 260, Assembly overview -
oil filter bracket and engine oil cooler.
– Pull 3-pin connector off engine speed sender -G28-.
– Using a commercially available ball-ended hexagon key
socket, loosen securing bolt -arrow- through opening in
crankcase, and pull out engine speed sender -G28-.
2.6.2 Installing
Installation is carried out in the reverse order. When installing,
note the following:
– Tighten securing bolt for engine speed sender -G28- to 5 Nm
3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
178
Repair Group 13 - Crankshaft group
To Next Page
Loading...
Need help?
General
