– Push new fuel filter -2- into fuel filter bracket -1- until it en-
gages.
– Fit fuel lines -3- and -4-, and secure them with clamps.
Bleeding fuel system
Procedure:
Note
If there is any air left in the fuel system, the engine may switch
to the backup mode ('emergency running' mode) during the
road test. Switch off the engine and clear the event memory.
1.7 Removing and installing supplementary
fuel pump -V393- (inline electronic fuel
pump)
Special tools and workshop equipment required
â—† Hose clip pliers -VAS 6340-
â—† Torque wrench -V.A.G 1331-
Removing
– Note safety precautions before beginning work ⇒ Page 299.
– Observe rules for cleanliness ⇒ Page 300.
– Move clear fuel hose, open clamp, and pull fuel hose off fuel
filter.
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
3
1 Removing and installing parts of fuel supply system
313
To Next Page
Loading...
Need help?
General
