ABB ACS320 User Manual

20 Introduction to the manual
Contents of this manual
The manual consists of the following chapters:
• Safety (page 15) gives safety instructions you must follow when installing,
commissioning, operating and servicing the drive.
• Introduction to the manual (this chapter, page 19) describes applicability, target
audience, purpose and contents of this manual. It also contains a quick
installation and commissioning flowchart.
• Operation principle and hardware description (page 23) describes the operation
principle, layout, power connections and control interfaces, type designation label
and type designation information in short.
• Mechanical installation (page 29) tells how to check the installation site, unpack,
check the delivery and install the drive mechanically.
• Planning the electrical installation (page 35) tells how to check the compatibility of
the motor and the drive and select cables, protections and cable routing.
• Electrical installation (page 45) tells how to check the insulation of the assembly
and the compatibility with IT (ungrounded) and corner grounded TN systems as
well as connect power cables, control cables and embedded fieldbus.
• Installation checklist (page 57) contains a checklist for checking the mechanical
and electrical installation of the drive.
• Start-up (page 59) tells how to start up the drive as well as how to start, stop,
change the direction of the motor rotation and adjust the motor speed through the
I/O interface. In addition, the chapter gives a brief description of each application
macro together with a wiring diagram showing the default control connections. It
also explains how to save a user macro and how to recall it.
• Application macros (page 79) gives a brief description of each application macro
together with a wiring diagram showing the default control connections. It also
explains how to save a user macro and how to recall it.
• Program features (page 99) describes program features with lists of related user
settings, actual signals, and fault and alarm messages.
• Actual signals and parameters (page 143) describes actual signals and
parameters. It also lists the default values for the different macros.
• Fieldbus control (page 283) tells how the drive can be controlled by external
devices over a communication network using embedded fieldbus
• Fault tracing (page 359) tells how to reset faults and view fault history. It lists all
alarm and fault messages including the possible cause and corrective actions.
• Maintenance and hardware diagnostics (page 377) contains preventive
maintenance instructions and LED indicator descriptions.
• Technical data (page 383) contains technical specifications of the drive, for
example, ratings, sizes and technical requirements as well as provisions for
fulfilling the requirements for CE and other marks.
• Dimension drawings (page 403) shows dimension drawings of the drive.

ABB ACS320 Specifications

General

Overload Capacity	150% for 60 seconds
IP Rating	IP20
Frame Size	R1 to R3
Enclosure Rating	IP20
Frequency Range	0 to 500 Hz
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overload, Short circuit, Ground fault, Overtemperature
Fieldbus Communication	Modbus RTU, PROFIBUS DP, CANopen
Communication Interfaces	RS485
Operating Temperature	-10 to +50 °C (14 to 122 °F)
Storage Temperature	-40°C to +70°C
Humidity	Less than 95% (non-condensing)
Supply Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)
Input Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)