ABB ACS320 User Manual

Fieldbus control 335
BACnet object definitions
 Object/Property support matrix
The following table summarizes the object types/properties supported:
* For commandable values only.
Property
Object Type
Device
Binary
Input
Binary
Output
Binary
Value
Analog
Input
Analog
Output
Analog
Value
Object Identifier 
Object Name 
Object Type 
System Status 
Vendor Name 
Vendor Identifier 
Model Name 
Firmware Revision 
Appl Software Revision 
Protocol Version 
Protocol Revision 
Services Supported 
Object Types Supported 
Object List 
Max APDU Length 
Segmentation Support 
APDU Timeout 
Number APDU Retries 
Max Master 
Max Info Frames 
Device Address Binding 
Database Revision 
Present Value 
Status Flags 
Event State 
Out-of-Service 
Units 
Priority Array  *  *
Relinquish Default  *  *
Polarity 
Active Text 
Inactive Text 

ABB ACS320 Specifications

General

Overload Capacity	150% for 60 seconds
IP Rating	IP20
Frame Size	R1 to R3
Enclosure Rating	IP20
Frequency Range	0 to 500 Hz
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overload, Short circuit, Ground fault, Overtemperature
Fieldbus Communication	Modbus RTU, PROFIBUS DP, CANopen
Communication Interfaces	RS485
Operating Temperature	-10 to +50 °C (14 to 122 °F)
Storage Temperature	-40°C to +70°C
Humidity	Less than 95% (non-condensing)
Supply Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)
Input Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)