ABB ACS320 User Manual

60 Start-up
• Language selection for the display
• Drive connection that can be made or detached at any time
• Start-up assistant to facilitate drive commissioning
• Copy function for moving parameters to other ACS320 drives
• Backup function for saving parameter sets
• Context sensitive help
• Real-time clock
 General display features
Soft key functions
The soft key functions are defined by text displayed just above each key.
Display contrast
To adjust display contrast, simultaneously press and or , as
appropriate.
Macros
Note: Selecting the appropriate macro should be part of the original system design,
since the control wiring installed depends on the macro used.
1. Review the macro descriptions in section Application macros on page 79. Use the
macro that best fits system needs.
2. Edit parameter 9902 APPLIC MACRO to select the appropriate macro. Use either
of the following:
• Use the Start-up assistant, which displays the macro selection immediately
after motor parameter setup.
• Refer to section Parameters mode on page 66 for parameter editing
instructions.
Turning - parameters
The system can benefit from one or more of the ACS320 special features, and/or fine
tuning.
1. Review the parameter descriptions in section Parameter listing starting on
page 148. Enable options and fine tune parameter values as appropriate for the
system.
2. Edit parameters as appropriate.

ABB ACS320 Specifications

General

Overload Capacity	150% for 60 seconds
IP Rating	IP20
Frame Size	R1 to R3
Enclosure Rating	IP20
Frequency Range	0 to 500 Hz
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overload, Short circuit, Ground fault, Overtemperature
Fieldbus Communication	Modbus RTU, PROFIBUS DP, CANopen
Communication Interfaces	RS485
Operating Temperature	-10 to +50 °C (14 to 122 °F)
Storage Temperature	-40°C to +70°C
Humidity	Less than 95% (non-condensing)
Supply Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)
Input Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)