ABB ACS320 User Manual

68 Start-up
 Start-up assistant mode
To start the Start-up assistant, follow these steps:
The Start-up assistant will guide you through the start-up.
The Start-up assistant guides you through the basic programming of a new drive.
(Familiarize yourself with basic control panel operation and follow the steps outlined
above.) At the first start, the drive automatically suggests entering the first task,
language select.The assistant also checks the values entered to prevent entries that
are out of range.
The Start-up assistant is divided into tasks. You may activate the tasks one after the
other, as the Start-up assistant suggests, or independently.
Note: If you want to set the parameters independently, use the Parameters mode.
1
Select MENU to enter the main
menu
2
Select ASSISTANTS with the
Up/Down buttons and select
ENTER.
3
Scroll to Commission drive with
the Up/Down buttons and select
SEL.
4
Change the values suggested by
the assistant to your preferences
and then press SAVE after every
change.
0 A
0 %
0 mA0.
0.
0.
0.0HzOFF
MENU
SP
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
OFF MAIN MENU 2
Spin the motor
Commission drive
References 1 & 2
Start/Stop Control
Protections
EXIT
SEL
ASSISTANTS 2
OFF
9901 LANGUAGE
PAR EDIT
ENGLISH
[0]
OFF
EXIT SAVE

ABB ACS320 Specifications

General

Overload Capacity	150% for 60 seconds
IP Rating	IP20
Frame Size	R1 to R3
Enclosure Rating	IP20
Frequency Range	0 to 500 Hz
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overload, Short circuit, Ground fault, Overtemperature
Fieldbus Communication	Modbus RTU, PROFIBUS DP, CANopen
Communication Interfaces	RS485
Operating Temperature	-10 to +50 °C (14 to 122 °F)
Storage Temperature	-40°C to +70°C
Humidity	Less than 95% (non-condensing)
Supply Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)
Input Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)