Fortinet FortiGate Series Administration Guide

WAN optimization and web caching Configuring a WAN optimization rule
FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903 685
http://docs.fortinet.com/ • Feedback
Moving a rule to a different position in the rule list
You can arrange the WAN optimization rule list to influence the order in which rules are
evaluated for matches with incoming traffic. When more than one rule has been defined,
the first matching rule will be applied to the traffic session.
Moving a rule in the rule list does not change its ID, which only indicates the order in which
the rule was created.
Figure 426:Move rule
To move a rule in the WAN optimization rule list
1 Go to WAN Opt & Cache > Rule.
2 In the rule list, note the ID of a rule that is before or after your intended destination.
3 In the row corresponding to the rule that you want to move, select the Move To icon.
4 Select Before or After, and enter the ID of the rule that is before or after your intended
destination. This specifies the rule’s new position in the WAN optimization rule list.
5 Select OK.
Configuring a WAN optimization rule
This section describes the WAN optimization rule options. The options that appear in
WAN optimization rules depend on how you configure the rule. This section describes all
of the options.
To add a WAN optimization rule, go to WAN Opt. & Cache > Rule and select Create New.
Figure 427: Configuring a WAN optimization rule

Fortinet FortiGate Series Specifications

General

Brand	Fortinet
Model	FortiGate Series
Category	Firewall
Language	English