Name: Huawei FusionModule800
Brand: Huawei
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Figure 5-3 Normal mode

Step 4 After you ensure that the UPS runs properly, switch on the AC output circuit

breaker Q for the UPS to start the load.

----End

5.1.1.2.2 Shutting Down a UPS

Normal Mode

On the default screen, press and hold OFF/ENTER for more than 5s. Release the

button when you hear the buzzer buzzing. The UPS inverter is shut down. The UPS

transfers to bypass mode when the mains is available.

Battery Mode

In battery mode, press and hold OFF/ENTER for more than 5s. Release the button

when you hear the buzzer buzzing. The UPS in battery mode is shut down.

Shutting Down the Inverter to Transfer the UPS to the No Output State

Step 1 Shut down loads.

Step 2 Perform the startup operation on the UPS. The UPS shuts down the inverter and

transfers to bypass mode. If mains parameters are inconsistent with bypass

parameters, the UPS transfers to standby mode.

Step 3 Switch

o the AC input circuit breaker K

and output circuit breaker Q for the

UPS. After all indicators turn

o and fans stop, the UPS shuts down and the loads

power

o.

----End

5.1.1.2.3 Performing EPO

Turn on the EPO switch (provided by the customer). The UPS enters the EPO state.

That is, the UPS shuts down the inverter, and does not transfer to the bypass

mode.

FusionModule800 Smart Small Data Center

User Manual 5 Power-On Commissioning

Huawei FusionModule800 User Manual

Other manuals for Huawei FusionModule800