Step 7 Choose Monitoring > System > ECC800-Pro > Controls and delete the device
failing in communication.
Step 8 Refer to the section about commissioning the in-room access control system in the
installation guide and check that the access actuator functions properly.
Step 9 Choose Home > Plan View and add a new access actuator in the appropriate
position.
----End
6.4.4.20 Replacing a Fingerprint and Card Reader with a Keypad
Prerequisites
● Recommended tool: Phillips screwdriver
● A
ngerprint and card reader with a keypad needs to be replaced.
● A spare ngerprint and card reader with a keypad of the same model is
available and functional.
Context
Figure 6-75 Fingerprint and card reader with a keypad
Procedure
Step 1 Remove the screws that secure the ngerprint and card reader with a keypad, and
remove the cable, as shown by (1), (2), and (3) in Figure 6-76.
FusionModule800 Smart Small Data Center
User Manual 6 O&M
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 482
To Next Page
Loading...
Need help?
General