Step 2 On the login page, enter the user name admin and preset password Change_Me,
and click Log In to enter the OMU portal page. A message is displayed upon the
rst login indicating that you should change the password. After changing the
password, keep it properly.
● If the device is VCN510, distinguish the VCN510-8 from the VCN510-16P. The VCN510-8
does not have eight PoE ports, and the VCN510-16P has PoE ports.
The default user name of the VCN510-8 is Admin, and that of the VCN510-16P is
admin.
Figure 5-44 VCN510-8 rear view
Figure 5-45 VCN510-16P rear view
● If the device is not VCN510 and the software version is V100R003 or later, the default
user name is admin. If the software version is V100R002 or earlier, the default user
name is Admin.
----End
5.3.11.5.2 Initializing VCN510 Disks
Context
When the VCN510 is delivered to the site, recording data can be stored only after
you install and initialize the disks.
Procedure
Step 1 Log in to the OMU portal of the VCN.
Step 2 Choose Local
Conguration > Local Disk.
Step 3 In the upper-right corner of the RAID Groups area, click Initial disk.
FusionModule800 Smart Small Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 314
To Next Page
Loading...
Need help?
General