Procedure
Step 1 Set the IP address of the EDCM server.
1. When you log in to the app for the rst time, the Server Settings screen is
automatically displayed.
2. Enter the server IP address and tap Next.
In the lower right corner of the login screen, choose > Server settings to update the
server IP address.
Step 2 Open the EDCM app, and enter the Organization, Username, and Password.
● Organization and Username are the tenant name registered on HUAWEI CLOUD.
● If you fail to log in for three consecutive times, the system automatically displays
Verication code.
Step 3 Tap Log In.
If no data is displayed on the screen or a message indicating a network error is displayed,
check whether the mobile device has properly connected to a WiFi or mobile network. If
the network is normal, check whether you have been forcibly logged out on the NetEco.
----End
5.3.13.2.6 Setting EDCM Communication Parameters on the ECC800-Pro
The ECC800-Pro can connect to the EDCM only after EDCM communication
parameters are set on the ECC800-Pro WebUI.
FusionModule800 Smart Small Data Center
User Manual 5 Power-On Commissioning
Issue 01 (2021-02-05) Copyright © Huawei Technologies Co., Ltd. 351
To Next Page
Loading...
Need help?
General