Driving modes and rigging for on-road driving
6.4 Installing/removing outrigger beams
6 - 40 3 112 993 en Operating manual GMK 6400
12.07.2013
6.4.3 Preparing the truck crane
Requirements The following requirements must be met before mounting/removing the
outrigger beams:
– All rigging work which involves slewing the superstructure was com-
pleted.
– The parking brake is engaged.
– The truck crane has been levelled with the level adjustment system;
à p. 5 - 60.
– The corresponding covers have been removed (1).
– The suspension is switched off (blocked), and the symbol (1) is red;
à p. 5 - 14.
For removal Each outrigger beam is designed for just one installation point. If, for exam-
ple, you remove the outrigger beam on the rear left hand side, you must
mount the same outrigger beam on the rear left hand side again.
Labelling the outrigger beams
• Before you remove all outrigger beams for the first time, label them with
the correct installation point and if necessary, also with the serial number
of the truck crane.
Releasing the outriggers
All outrigger beams are retracted.
• Pull out the pin (1).
Lock the outrigger beams together
• Insert the pins (2).
To Next Page
Loading...
Need help?
General
