Driving with rigged truck crane
13.2 Permissible rigging modes and axle loads
13 - 2 3 112 993 en Operating manual GMK 6400
12.07.2013
13.2 Permissible rigging modes and axle loads
Depending on the counterweight rigged, you must bring the superstructure
and the main boom into certain positions so that the permissible axle loads
are not exceeded.
• Enter the RCL code for the actual rigging mode of the truck crane in
accordance with the
Lifting capacity table.
• Bring the superstructure and the main boom into a position that is indi-
cated in the following table for the specified counterweight rigged.
• Tie down the hook block so that it cannot swing around.
S
Risk of damage to the axle lines
Only bring the superstructure and the main boom into the specified posi-
tions. This prevents excessive strain on the axle lines.
G
Risk of accident if the RCL is overridden
Always enter the RCL code for the current rigging mode. The specified posi-
tions are within the monitored operating ranges.
If the RCL is overridden, the truck crane may overturn even if you move it
into the positions specified.
To Next Page
Loading...
Need help?
General
