Starting/turning off the engine – for crane operation
10.3 Turning off the engine
Operating manual GMK 6400 3 112 993 en 10 - 17
12.07.2013
10.3 Turning off the engine
10.3.1 During normal operation, with the ignition lock/with the hand-
held control
If the hand-held control is not connected:
• Turn the ignition key to position 0 – the engine will stop.
If the hand-held control is connected:
• Press the button (1) once – the engine goes off.
It is not possible to switch off the engine with the ignition lock.
After turning off Observe the notes in the appropriate sections;
à In case of short work breaks, p. 11 - 128,
à In case of work breaks of more than 8 hours, p. 11 - 129.
G
Risk of accident by suspended loads
Never turn off the engine with a suspended load. You must have the control
levers at hand in order to intervene at any time.
Always set down the load before you leave the crane cab.
To Next Page
Loading...
Need help?
General
