Rigging work
12.8 Rigging the auxiliary hoist
Operating manual GMK 6400 3 112 993 en 12 - 99
12.07.2013
12.8.6 Raising/setting down the catcher
When operating the auxiliary hoist, the catcher must be raised so that the
cable run is not impeded by the upper hook block.
To raise and lower the catcher you must:
– Connect the hand-held control;
à p. 12 - 21,
– Check that the upper hook block is secured when it lies in the catcher;
à p. 12 - 106.
Raising
• Connect the hand-held control; à p. 12 - 21.
When the upper hook block lies in the catcher:
• Check that the upper hook block is secured; à p. 12 - 106.
• Press the button (1). The lamp lights up.
• Press the key combination (2) until the catcher is fully raised.
Setting down
• Connect the hand-held control; à p. 12 - 21.
When the upper hook block lies in the catcher:
• Check that the upper hook block is secured; à p. 12 - 106.
• Press the button (1). The lamp lights up.
• Press the key combination (2) until the catcher is fully set down.
To Next Page
Loading...
Need help?
General
