Overview
1.11 EC Declaration of Conformity
1 - 34 3 112 993 en Operating manual GMK 6400
12.07.2013
1.11 EC Declaration of Conformity
On initial delivery, operators of truck cranes receive a Declaration of Con-
formity as a supplement to the delivery protocol. An illustration of the Dec-
laration of Conformity is shown below.
This Declaration of Conformity is only valid if
the rated capacity limiter of the truck crane is
programmed in accordance with the stand-
ards and technical specifications stated in the
relevant EC Declaration of Conformity and if
the truck crane specified here is in rigging
mode for initial delivery state or rigging mode
for completed state. Only then does the truck
crane receive a CE mark upon delivery. If the
truck crane is programmed otherwise on
delivery, no CE mark is given. If this truck
crane is later imported into an EC member
state, the importer is responsible for checking
and confirming that the truck crane's rated
capacity limiter programming and current rig-
ging mode correspond to guidelines specified
in the Declaration of Conformity enclosed with
the truck crane. For the purposes of checking
and confirming, we recommend contacting
the crane manufacturer or a person authorised
by the same. After successful confirmation,
the truck crane can be assigned a CE mark and
the original CE Declaration of Conformity
enclosed becomes valid. Consequently, the
standards and requirements valid at the time
of initial delivery thereafter apply to this crane.
To Next Page
Loading...
Need help?
General
