Crane operation
11.4 Settings and displays for crane operation
Operating manual GMK 6400 3 112 993 en 11 - 105
12.07.2013
11.4 Settings and displays for crane operation
This section only describes settings and displays needed during crane oper-
ation. Operating elements that can be assigned to other procedures are
described with the corresponding procedures.
11.4.1 Inclining the crane cab
With the appropriate equipment, you can incline the crane cab to the rear in
order to attain a better sitting position when working at great heights.
For Mega Wing Lift additional equipment, if this is in the rigging position,
then inclining the cab will be disabled – in the rigging submenu, the Mega
Wing Lift symbol (1) will be red.
(A) – To incline to the rear
• Close the crane cab door
• Press button (1) down
(B) – To incline to the front
• Close the crane cab door
• Press button (1) up
The crane cab will tilt as long as you hold the
button down or its end position is reached.
G
Risk of accident due to objects overturning in the crane cab
Close the crane cab door before inclining and remove all loose objects
(e.g. bottles) from the crane cab.
This prevents objects from tipping over, the crane cab door opening by
itself, and unintended operational accidents caused by fright.
To Next Page
Loading...
Need help?
General
