Rigging work
12.9 Rigging work on the main boom
12 - 114 3 112 993 en Operating manual GMK 6400
12.07.2013
12.9.3 Reeving and unreeving the hoist rope
You must reeve a certain number of rope lines, depending on the required
lifting capacity. Four reeved rope lines correspond, for example, to 4-fold
reeving.
Possible reevings and the corresponding lifting capacities;
à p. 12 - 119.
Rope end fitting To reeve and unreeve the hoisting rope, you must remove the rope end fit-
ting.
After reeving you must reattach the rope end fitting.
Removing the rope end fitting
• Pull the pin (2) and remove the fork element
(1).
• Slide the holder (3) back and remove it from
the hoist rope (4).
Reattaching the rope end fitting
• Insert the holder (3) and slide it onto the
hoist rope as far as it will go (4).
• Fasten the fork (1) using the pin (2).
• Secure the pin using the linchpin.
To Next Page
Loading...
Need help?
General
