Rigging work
12.5 Starting the engine for driving for rigging work
Operating manual GMK 6400 3 112 993 en 12 - 23
12.07.2013
12.5 Starting the engine for driving for rigging work
The engine for driving must be running for rigging work, e.g., to move the
outriggers. You can start the engine for driving:
– With the hand-held control
– From the crane cab
– From the operating elements of the outriggers
H
You can generally start the engine only if a bridging plug is inserted in all
sockets not required.
12.5.1 Starting/turning off the engine with the hand-held control
Requirements The following requirements must be met before you can start the engine for
driving with the hand-held control:
– The ignition is switched off in the crane cab
– The ignition is switched off in the driver's cab
• Connect the hand-held control to a socket on the carrier; à p. 12 - 22
H
If you connect the hand-held control to a carrier socket while the engine for
crane operation is running, that engine is shut off. In that case, you cannot
start the engine for driving since the ignition in the crane cab is still switched
on.
s
To Next Page
Loading...
Need help?
General
