2-5
2 Installation and Startup of NB-Designer
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
2-4 Installation of USB Driver for NB
2
2-4 Installation of USB Driver for NB
Install the USB driver for NB on PC.
After the installation, the data transmission between the PC and the NB Unit is available via USB.
Because the USB driver included in the NB-Designer is certified by Microsoft, it will be installed
automatically accompanying with the software installation, so there is no need to install the USB driver
by manual again.
Operating procedure
1
After the USB slave for the NB Unit and the computer are connected by the USB cable, “Found
New Hardware Wizard” will be displayed on PC. After selecting [Install the software
automatically (Recommended)], click the [Next] button.
2
USB driver is being installed.
To Next Page
Loading...
Need help?
General
