3-83
3 Functions of NB-Designer
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3-6 Parts
3
3-6-2 Bit Lamp
Bit Lamp displays the On/Off state of bit address inside a specified PT or of PLC device. If the
state is 0, the graphics with state of 0 will be displayed; If the state is 1, the graphics with state of 1 will
be displayed. If “Transport Font” is checked, the Label values corresponding to the different states can
be set and displayed.
Process of adding one Bit Lamp
1
Drag the Bit Lamp icon after it is pressed, then the [Basic Properties] dialog box for Bit Lamp
component will pop up.
Read Address: Refers to the bit address controlling the displayed information (such as the state,
graphics, label and so on) of the lamp.
Address: Refers to the bit address corresponding to the lamp.
2
Switch to the [Bit Lamp] tab.
3-6-2 Bit Lamp
To Next Page
Loading...
Need help?
General
