Siemens SINUMERIK ONE MCP 2400.4c Programming Manual

Program organization
The program organization on external program memories is shown in the following diagram:
$Q\GULYH
SS[[[
0\6XE363)
6+$)7
0\3URJ0SI
PRUH3URJV
3URJV
&\FOHV
*OREDOSDUWSURJUDP
PHPRU\*',5
68%63)
68%63)
352*03)
352*03)
B1B68%B63)
B1B68%B63)
B1B352*B03)
B1B352*B03)
3DUWSURJUDPPHPRU\
3DVVLYHILOHV\VWHPLQWKH1&.
([WHUQDOSURJUDPPHPRU\

'(9
B1B&86B',5
B1B&0$B',5
B1B&67B',5
'(9
:.6',5
63)',5
03)',5
:.6',5
63)',5
03)',5
Case-insensitive file systems
Note
To avoid problems with case-sensitivity for the file addressing (see "Addressing program
memory files (Page 554)"), case-insensitive file systems should be used as external program
memory.
3.4.1.3 Addressing program memory files
A file in the program memory, which is addressed with a file handling command (e.g. WRITE,
DELETE, READ, ISFILE, FILEDATE, FILETIME, FILESIZE, FILESTAT, FILEINFO), is
referenced with an absolute path plus file names or only with the file names. In the second case,
the path of the selected program is used as file path.
Work preparation
3.4 File and Program Management
NC programming
554 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English