3.20 Grinding
3.20.1 Activate/deactivate grinding-specific tool monitoring (TMON, TMOF)
With the predefined procedures TMON(...) and TMOF(...), the grinding-specific tool monitoring
is activated or deactivated (geometry and speed monitoring).
Requirement
The tool-specific parameters $TC_TPG1 to $TC_TPG9 must be set.
Syntax
TMON(<TNo>)
...
TMOF(<TNo>)
Meaning
TMON(...): Activate grinding-specific tool monitoring
The command must be programmed in the channel in which the grinding-specific tool
monitoring is to be activated.
TMOF(...): Deactivate grinding-specific tool monitoring
The command must be programmed in the channel in which the grinding-specific tool
monitoring is to be deactivated.
<TNo>: T number
Note:
Only required if the monitoring is to be switched on or off for an inactive grinding wheel
rather than the active grinding wheel that is currently in use.
TMOF(0): Deactivate monitoring for all tools
Work preparation
3.20 Grinding
NC programming
974 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
Need help?
General
