2.4.3 Behavior with faulty T programming
The behavior with faulty T programming depends on the configuration of the machine:
MD22562 TOOL_CHANGE_ERROR_MODE
Bit Value Meaning
7 0 Basic setting!
With the T programming, a check is made immediately as to whether the NC recogni‐
zes the T number. If not, an alarm is triggered.
1 The programmed T number will only be checked following D selection. If the NC does
not recognize the tool number, an alarm is issued during D selection.
This response is desirable if, for example, tool programming is also intended to achieve
positioning and the tool data is not necessarily available (circular magazine).
Fundamentals
2.4 Tool change
NC programming
66 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
Need help?
General
