8B-54 Air Bag System:
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.
3 1) With ignition switch OFF, disconnect special tools (B)
and (C) from “G67” connector and SDM connector “G47”
and “G46” from SDM respectively.
2) Release shorting bar in SDM connector inserting release
tool (1) included in special tool (A).
3) Measure voltage between “G47-3” and body ground,
and between “G47-4” and body ground [A] or between
“G46-5” and body ground, and between “G46-6” and
body ground [B].
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–77320
With ignition switch ON, is voltage 4 V or less?
Substitute a known-
good SDM and recheck.
“BLU/RED” or “YEL/
RED” circuit shorted to
power supply circuit.
(Between “G67” and
“G47” connectors or
between “G67” and
“G46” connectors).
Step Action Yes No
PASSENGER
DRIVER
(B)
(C)
STEERING WHEEL
“G67”
[B]
[A]
“G47-3”
“G47-4”
“G46-5” “G46-6”
(A)
1, (A)
I5JB0A820037-01
To Next Page
Loading...
Need help?
General
