Automatic Transmission/Transaxle: 5A-127
3) Measure free length of reverse brake piston return
spring.
Standard free length of reverse brake piston
return spring
16.84 mm (0.663 in.)
4) Install reverse brake piston assembly and brake
piston return spring to transmission case, using care
not to damage O-ring. Then install snap ring (1) with
special tools.
NOTE
• Install so that opening in snap ring (1) will
not align with any of 3 lugs of spring seat.
• Do not compress spring more than
necessary and do not allow it fall or tilt.
Special tool
(A): 09926–98320
(B): 09926–98390
(C): 09944–88210
5) Prepare a stand as shown. It is necessary because
work will be done with transmission case (1) set
upright from this step on.
NOTE
• To protect transmission case against
damage, spread cloth on stand where case
contacts.
• A stand of such size as shown in the figure
will facilitate work.
6) Install thrust bearing (1) and thrust bearing race (2)
after lubricating them with grease.
NOTE
Make sure that thrust bearing output shaft
race is installed in proper direction.
7) Install brake applying tube (1) so that its lug (2) fits in
a in transmission case (4). After installation, check
that 4 lugs (3) along the underside of brake applying
tube fit inside of reverse brake piston.
8) Install leaf spring (1) as shown in figure.
2. Nut M12 x 1.75
A: 50 mm (1.9 in.) C: 400 mm (15.7 in.)
B: 350 mm (13.8 in.) D: 200 mm (7.9 in.)
1
2
(C)
(A)
(B)
I5JB0A510128-01
1
C
A
D
B
I5JB0A510079-01
I5JB0A510160-01
2
1
3
4
I5JB0A510130-02
1
I5JB0A510131-02
To Next Page
Loading...
Need help?
General
