About This Documentation
Documentation Design and Purpose
This Service Documentation contains diagnostic, repair, and maintenance Information, which
has been designed to assist the Service Representative in the isolation and repair of faults as
well as maintenance of the 8830 DDS.
This documentation assumes that the user is familiar with the electrical and mechanical stan-
dards that are commonly used throughout industry, as well as certain Xerox design and docu-
mentation conventions. This documentation also assumes that the user has successfully
completed any required training and is familiar with the use of any special tools that are
required to service this product.
Applicability
This documentation contains information that applies to units built for United States Operations
(USO), Xerox Canada Limited (XCL), America's Operations (AO), and Xerox Limited (XL).
Normally the diagnostic, repair, and adjustment procedures found In this documentation apply
equally to all SO Hz and 60 Hz machine versions. Some procedures, however, may be identi-
fied as being applicable to a specific version or machine configuration.
Limitations
This service documentation does not support specific electrical, mechanical, or operational
considerations of any accessory device or machine modification not authorized by Xerox Cor-
poration for this product.
Service Documentation Revisions
This service documentation may be subject to periodic revision in order to reflect any changes
in electrical or mechanical hardware, as well as any possible additions or corrections neces-
sary to ensure the technical accuracy of the documentation.
Field Service Bulletins
Field service Information specifically applicable to the machine may occasionally be Issued in
the form of electronic or critical bulletins. Because bulletins contain important information, they
should always be retained within this service documentation for quick reference.
Publication Comment Sheet (PCS - hardcopy only)
A publication Comment Sheet (PCS) is provided at the end of this service documentation
(hardcopy only). The PCS form is used to communicate pertinent Information to Multinational
Customer & Service Education (MC&SE) regarding the effectiveness and technical accuracy
of this documentation.
Organization
This documentation is divided into eight sections. In addition to the Introduction, the following
sections are contained within this documentation.
Section 1 • Service Call Procedures
Section 2 - Status indicator RAPs
Section 3 - Image Quality RAPs • (Section not used at this time.)
Section 4 - Repair/Adjustment Procedures
Section 5 • Parts List
Section 6 • General Procedures/Information
Section 7 - Wiring Data
Section 8 * Accessories (Section not used at this time.)
A detailed description of the information contained within each section of the service documen-
tation will be found in the following subsection.
8830 DDS
3/98
VII
Introduction
About This Documentation
To Next Page
Loading...
Need help?
General
