3-45
ADJUSTING THE REAR BRAKE LIGHT SWITCH/
CHECKING THE FRONT AND REAR BRAKE HOSES
CHK
ADJ
A
B
NOTE:
a
b
EAS00128
ADJUSTING THE REAR BRAKE LIGHT
SWITCH
The rear brake light switch is operated by move-
ment of the brake pedal. The rear brake light
switch is properly adjusted when the brake light
comes on just before the braking effect starts.
1. Check:
S rear brake light operation timing
Incorrect ! Adjust.
2. Adjust:
S rear brake light operation timing
a. Hold the main body
1
of the rear brake light
switch so that it does not rotate and turn the
adjusting nut
2
in direction
a
or
b
until the
rear brake light comes on at the proper time.
Direction
Brake light comes on
sooner.
Direction
Brake light comes on
later.
EAS00131
CHECKING THE FRONT AND REAR BRAKE
HOSES
The following procedure applies to all of the
brake hoses and brake hose clamps.
1. Check:
S brake hose
Cracks/damage/wear ! Replace.
A
Front
B
Rear
2. Check:
S brake hose clamp
Loose ! Tighten the clamp bolt.
3. Hold the motorcycle upright and apply the
brake several times.
4. Check:
S brake hose
Brake fluid leakage ! Replace the damaged
hose.
Refer to “FRONT AND REAR BRAKES” in
chapter 4.