Yamaha FZ6-SS - Installing the Swingarm

4-72
SWINGARM AND DRIVE CHAIN
CHAS
120 Nm (12 mSkg, 87 ftSlb)
4. Check:
S dust covers
1
S spacer
2
Damage/wear ! Replace.
S bearings
Damage/pitting ! Replace.
AS00711
INSTALLING THE SWINGARM
1. Lubricate:
S bearings
S spacer
S dust covers
S pivot shaft
Recommended lubricant
Lithium-soap-based grease
2. Install:
S swingarm
1
S pivot shaft nut
2
3. Install:
S rear shock absorber assembly
S rear wheel
Refer to “INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY” and “INSTAL-
LING THE REAR WHEEL”.
4. Adjust:
S drive chain slack
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
Drive chain slack
45 X 55 mm (1.77 X 2.17 in)