8-85
SMART KEY SYSTEM
EAS32446
REPLACING THE REMOTE CONTROL UNIT, STEERING LOCK, AND ECU
The remote control unit, steering lock, and ECU cannot be replaced at the same time.
EAS32447
REPLACING THE REMOTE CONTROL UNIT
1. Replace the remote control unit, and then place only 1 previously used smart key within 80 cm
(31.5 in) of the remote control unit.
2. Push the ON/start switch.
3. Push the OFF/LOCK switch, and then push the ON/start switch to check that the operation is correct.
4. Register any additional smart keys.
• If multiple smart keys were registered to the previous remote control unit, perform the preceding pro-
cedure for only 1 smart key. Do not perform the procedure for multiple smart keys at the same time.
• If the smart key identification number matches, it can be determined that the replacement procedure
is being performed for a legitimate user. Write the remote control unit identification number and smart
key identification number to the remote control unit and overwrite the smart identification number on
the smart key with the new number.
EAS31556
REPLACING THE STEERING LOCK UNIT
1. Replace the steering lock unit, and then place the previously used smart key within 80 cm (31.5 in)
of the remote control unit.
2. Push the ON/start switch.
3. Push the OFF/LOCK switch, and then push the ON/start switch to check that the operation is correct.
An identification number is not written to the steering lock unit when it is shipped from the factory. When
the vehicle system is turned on for the first time, the remote control unit identification number and smart
key identification number are automatically registered from the remote control unit to the steering lock
unit.
EAS31541
REPLACING THE ECU
1. Replace the ECU, and then place the previously used smart key within 80 cm (31.5 in) of the remote
control unit.
2. Push the ON/start switch.
3. Push the OFF/LOCK switch, and then push the ON/start switch to check that the operation is correct.
An identification number is not written to the ECU when it is shipped from the factory. When the vehicle
system is turned on for the first time, the remote control unit identification number is automatically writ-
ten from the remote control unit to the ECU.
To Next Page
Loading...
Need help?
General
