Abbott i-STAT 1 System Manual

Art: 725708-00E Rev. Date 07-FEB-12 4
Ensure your i-STAT 1 Handheld has enough battery power (7.5 volts or higher).
To do this:
• Press the On/Off ( ) key
• Press the MENU key
• Press 1 for Analyzer Status
• Confirm the battery voltage
I f using a Serial Downloader or Serial Downloader/Recharger, connect the i-STAT 1
Serial Downloader or the DRS-300 to the 9-pin serial por t on the back of the
computer with the 9-pin null modem serial cable as shown.
If using a DRC-300, connect the DRC-300 to the USB port on the back of the
computer with the USB cable as shown. Note: These instructions assume that
the DRC-300 has already been installed per Art. 728690: “The i-STAT 1
Downloader/Recharger (model number DRC-300)” for serial communications.
Rechargeable Batteries Disposable Batteries
If you have disposable batteries,
replace with fresh ones.
If you have rechargeable batteries,
c
harge your Handheld until it has
at least 7.5 volts.

1.2
1.3
Connecting/Setting Up Equipment
i-STAT 1 JammLite Utility

Abbott i-STAT 1 Specifications

General

Brand	Abbott
Model	i-STAT 1
Category	Measuring Instruments
Language	English