Abbott i-STAT 1 System Manual

Art: 725708-00E Rev. Date 07-FEB-12 10
Run the Electronic Simulator in the Handheld.
When the simulator finishes, PASS should be displayed.
If PASS is not displayed,
re-run the Electronic Simulator.
If the repeated Electronic
Simulator attempt fails, please
contact APOC Technical Support.
If there are no additional Handhelds to update, the process is complete:
• Click the button in the upper right corner of the software screen
• Close all other open boxes
• Confirm all messages
If there are additional Handhelds to update via JammLite:
• Click Close
• Click Update
• Repeat Steps through
If there are additional handhelds to update with the Handheld-to-Handheld process:
• Go to on page 11
If your facility uses Central Data Station:
• You must proceed to on page 16.
Congratulations. The process for updating
the first i-STAT 1 Handheld is complete.
Review the options below for additional instructions.
X
For additional information on
running the electronic simulator,
please see:
• Section 14 of the i-STAT 1
System Manual, or
• The Introduction and Start-up
section of the i-STAT System
Manual for Waived Tests
Verifying Software Update
i-STAT 1 JammLite Utility
1.17
1.14 1.17
2.
3.

Abbott i-STAT 1 Specifications

General

Brand	Abbott
Model	i-STAT 1
Category	Measuring Instruments
Language	English