Essential Items to Be Performed Before Installation
• Turn OFF the main power of the host machine, and disconnect the power plug from the outlet.
WARNING:
• If performing work without disconnecting the power plug of the host machine, it may cause electrical shock.
• If disconnecting the power plug without turning OFF the main power, it may cause damage of the machine.
• When turning OFF the main power, follow the below procedure.
1. Turn OFF the main power switch of the host machine.
2. The display in the Control Panel and the lamp of the main power are turned off.
Points to Note When Turning ON/OFF the Main Power
The following message is displayed.
1. When a message prompting to turn OFF and then ON the main power appears, turn OFF and then ON the main power
switch.
2. If a message prompting the user to update the version appears, press [Update] to automatically update the version
of this equipment.
If [Skip] is selected, a message prompting the user to update the version will appear every time the host machine is started.
In the service mode (Lv. 2) shown below, it is possible to set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Safety Precautions
3
To Next Page
Loading...
Need help?
General