4.
5.
Operation Check
1. Connect the power plug of the host machine to the outlet.
2. Turn ON the main power switch.
CAUTION:
If the reader unit error such as "E732-0023" or "E280-0002” is displayed after turning ON the main power switch, turn OFF
and then ON the main power switch, and then perform the following steps.
3. The message confirming the cable connection of the Reader Unit is displayed.
4. Set "0" for the following service mode.
COPIER > OPTION > FNC-SW > W/SCNR
COPIER > FUNCTION > INSTALL > FAX-USE
5. Exit service mode.
6. Turn OFF and then ON the main power switch.
3. Image Reading System Options
168
To Next Page
Loading...
