Multi-drawer Paper Deck-E1
Checking before Installation
The installation site must satisfy the conditions given below.
Therefore, it is recommended that the installation site be looked over before delivering this equipment to the customer.
CAUTION:
• Install the host machine first and then install this equipment.
• Do not carry this equipment with the host machine is installed for prevention of breakage.
â– Checking the Unpacking Space
Be sure to unpack this equipment according to the illustrations in a wide area where there is enough space around it.
Slope Plate
1115 mm
990 mm
1158 mm
1275 mm
1115 mm
805 mm
2885 mm
965 mm
Pallet
Paper Deck
â– Checking the Power Supply
1. The equipment must be connectable to the outlet that can supply the rated voltage +10/-15% at the specified ampere or
higher.
2. When connecting the power plug of this equipment to an outlet, be sure to use an outlet of a system different from that of
the host machine.
3. Install this equipment near the power outlet and leave sufficient space around the power plug so that it can be unplugged
easily in an emergency.
5. Paper Feed Options
407
To Next Page
Loading...
Need help?
General