• Unused parts
[6] Spacer 1x
[4] Latch Plate B 1x
[5] Wire Saddle 1x [7]
JAM Label 1x
B
B
41 in the Accessory Box
[1] Latch Plate A 1x [2] Screw
(RS Tightening;
M4x8) 3x
[3] Db Label 1x
A
<Other>
Other bundled items such as leaflets, etc.
Installation Procedure
â– Preparing the Through Pass Unit
NOTE:
• The removed impact absorbing materials shall be stored to reuse for transportation in case of transference and the repair of
this Equipment.
1. Remove the Fixing Plate.
• 3 Screws (RS Tightening; M4x8)
5. Paper Feed Options
484
To Next Page
Loading...
Need help?
General