Unpacking Procedure
NOTE:
• At unpacking, the 2 Slope Plates are installed as shown in the figure. Be sure to secure a space to unpack, and then start
the installation work.
• This equipment is packed using tapes, fixings and cushioning materials to be protected vibration and shock during
transportation. Be sure to remove all the fixing materials and the tapes before starting to install this equipment.
â– Unpacking
1. Remove the packaging box.
2. Take out the included box.
CAUTION:
When unpacking, do not hold the Feed Guides, otherwise, the equipment may be deformed or damaged depending on the
holding positions.
6. Paper Output Options
677
To Next Page
Loading...
Need help?
General