EasyManua.ls Logo

Eaton SmartWire-DT SWD Series - Engineering

Eaton SmartWire-DT SWD Series
293 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 PKE-SWD-32, interface for motor-starter combination with PKE PKE12/32
4.3 Engineering
SmartWire-DT module IP20 01/20 MN05006001Z-EN www.eaton.com 87
The PKE-SWD-32 is set to the respective contactor size via the slide adjuster
for the contactor size . This enables the module to be set to size 1 (DILM7
to DILM15) contactors and size 2 (DILM17 to DILM32) contactors.
The PKE32-COM is used as a communication link between the PKE-SWD-32
and the PKE-XTUA-… trip block. The data is exchanged via the data interface
of the PKE trip block and the data interface on the PKE-SWD-32. The
PKE32-COM module is used for transferring the signals. This connects the
data interfaces of the PKE trip block and the PKE-SWD-32.The PKE-SWD-32
receives the data of the PKE trip block and makes this available on the Smart-
Wire-DT network.
The 1-0-A selector switch is used to manually make an electrical activation
of the connected contactor as required.
4.3 Engineering
The PKE-SWD-32 can be combined with DILM7 to DILM32 contactors in
conjunction with the PKE12 and PKE32 electronic motor protective circuit
breaker and the “Advanced” part no. (PKE-XTUA-…) trip blocks. The DILM7
to 32, PKE12 / PKE32 components and the PKE-XTUA-… trip block are avail-
able likewise as networkable motor starter combinations (MSC-DEA-…), and
can also be combined with the PKE-SWD-32.
Each PKE-SWD-32 can be connected to a DILM7 to DILM32 contactor and a
PKE12 to PKE32 with a PKE-XTUA-... trip block. With reversing starters con-
sisting of two contactors and one PKE electronic motor protective circuit
breaker, the actuation of the second contactor can be implemented with the
DIL-SWD-32-001 or DIL-SWD-32-002 SmartWire-DT contactor modules
( Chapter 3, "Switching on DIL-SWD-32-001, DIL-SWD-32-002 contactors",
page 65).
Table 7: Combination options
The connected contactor is fed directly via the SmartWire-DT connection
cable. The contactor coils have the following power consumptions with a
voltage of 24 V DC:
Application Number of
PKE-SWD-32
Number of
DIL-SWD-32
Electronic motor starter MSC-DEA
DOL starter (PKE and DILM) 1 0
Reversing starter (PKE and 2 x DILM)
1 1

Table of Contents

Related product manuals