To Next Page

To Previous Page

Digital outputs

453

7.2.8.3 Output signal

Index

Id-Text

Name

Function

0x2614

0x261B

do20

do27

select flag O1 .. OD

select flag OA..OC

select flag relais

Selection of the flags or "connected flags" that are to be

linked to generate an output signal

0x2612

do19

AND operation for output

Selection if the flags are input to an OR or an AND link-

age for the generation of the outputs

For each hardware output (O1..O4, relay) and each software output (OA..OC), parame-

ters do20…do27 select flag Ox can be used to select the flags / connected flags where-

from the output signal shall be generated.

Before the linkage, the flags for the respective output can be inverted with parameters

do28[1..8] invert flags for output.

The type of linkage (OR / AND) is set with do19 AND operation for output.

The resulting internal output state is displayed in ru19 internal output state.

7.2.8.4 Structure overview

1fghfh

Figure 125: Comparator level

KEB COMBIVERT F6 Programming Manual

Other manuals for KEB COMBIVERT F6