Configuration of the diagnostic interface on the devices of control type A and K
The diagnostic interface can be configured on the devices of control type A and K via the
following options.
Node address of the device
Structure with configuration data for F6 / S6 opera-
tors and for connection to the file system
10.2.2.1 DIN66019 node id
In the KEB DIN66019-II protocol, each node is identified by its own node address. Each
node has a separate object directory.
On the devices of control type A and K there is only one object directory. Thus there is
one DIN66019-II node and one variable node address per device.
➢ To enable (e.g.) an automated detection of device replacement, the de-
fault value in productive systems should not be used.
10.2.2.2 DIN66019 baud rate
The communication speed can be adjusted via the baud rate. The following baud rates
are available depending on the control type.
The baud rate is 38400 bit/s after a power-on reset or after switching on
of the device and must be switched from the DIN66019 master to another
value, if required. The baud rate is reset to 38400 bit/s after approx. 10s if
the interface is not used.
To Next Page
Loading...
Need help?
General
