S 3 Features
3-114 Features *: Available for KX-TD1232 only.
• System administration can be performed on-line except for the
procedures of diagnosis.
If the system goes off-line, the system functions as if it was in power
failure. (Refer to Power Failure Transfer feature.)
Programming References
Section 4, System Programming,
[107] System Password
[813] Floating Number Assignment
[814] Modem Standard*
Feature References Section 3, Features,
System Programming with Station Message Detail
Digital Proprietary Telephone Recording (SMDR)
Operation References Not applicable.
System Programming with Digital Proprietary Telephone
Description This system can be programmed with a personal computer or a
digital proprietary telephone (DPT).
DPTs available for system programming are: KX-T7235 and KX-
T7230 (Display DPTs).
Two extensions are allowed to perform system programming. The
extensions available are:
(1) An extension that is connected to jack 1.
(2) An extension that is assigned as a manager.
For more information and programming instructions, refer to
Section 4, “System Programming.”
Conditions • During system programming the system operates normally.
• During system programming the extension is considered to be busy.
• The display on the DPT permits interactive programming.
• Only one access is allowed to system programming at any one time.
• To access system administration, a valid password must be entered.
The password is factory-programmed and can be changed.
• A personal computer can be used to perform system programming.
Programming References
Section 4, System Programming
[006] Operator / Manager Extension Assignment
[107] System Password
To Next Page
Loading...
Need help?
General
