4.3 System Programming
Automatic Access CO Line Group Assignment
103
System Programming 4-39
Description Assigns the sequence in which CO line groups will be accessed
when in Automatic Line Access mode. When a user dials the
feature number for automatic line access (default=9) or presses the
L-CO button, an idle line is hunted in the programmed CO line
group order.
Selection
CO line group number: 1 through 8,
eight entries (max.) in desired order
Default 12345678
Programming 1. Enter 103.
Display: Local Access
2. Press NEXT.
Display example: Access:12345678
3. Enter the CO line group numbers in priority from top to
bottom.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new order.
4. Press STORE.
5. Press END.
Conditions • There is a maximum of eight CO line groups. Up to eight CO line
group numbers can be entered.
• Automatic Line Access feature works only if Automatic Route
Selection mode is turned off in program [312] “ARS Mode.”
Feature References Section 3, Features,
Line Access, Automatic Line Preference – Outgoing
Line Access, Direct
To Next Page
Loading...
Need help?
General
