4.6 CO Line Programming
ISDN Outgoing CLIR Service Assignment
417
4-98 System Programming
Description Assigns whether ISDN CLIR (Calling Line Identification
Restriction) service is enabled or disabled for outgoing outside
calls. If disabled, the subscriber’s number of your system is
informed to the called party.
Selection • CO line number:
KX-TD816 – 05 through 08, ( =all CO lines)
KX-TD1232 – 01 through 24, ( =all CO lines)
• Enable / Disable
Default All CO lines – Enable
Programming 1. Enter 417.
Display: ISDN CLIR Send
2. Press NEXT.
Display: CO Line NO?–>
3. Enter a CO line number.
To enter CO line number 01, you can also press NEXT.
Display example: CO01:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another CO line, press NEXT or PREV, or
SELECT and the desired CO line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • In the case of KX-TD1232, CO01 through CO12 are for the Master
System and CO13 through CO24 are for the Slave, if available.
• To assign all CO lines to one selection, press the key at step 3. In
this case, the display shows the contents programmed for CO01.
• Program [416] “ISDN Line Number Assignment” is used to store the
subscriber’s number of your system that is informed to the called party.
Feature References Section 3, Features,
Calling Line Identification Restriction (CLIR)
CO Incoming Call Information Display
To Next Page
Loading...
Need help?
General
